Jeep 2011 Wrangler - User Guide - Manual (Page 16)

Height Adjustment
• Ratchet the front lever, located on the
outboard side of the seat, upward to
raise the seat height.
• Ratchet the lever downward to lower
the seat height.
Recliner
• Lift the recliner lever located on the
outboard side of the seat, lean back
and release at the desired position.
Driver’s and Passenger Easy Entry Seats (Two-Door)
• Push the lever on the seatback
rearward (toward the rear of the vehicle)
to tilt the entire seat forward.
• To return the seat to a sitting position,
rotate the seatback upright until it locks.
Push the seat rearward until the track
locks.
NOTE:
• If equipped with a combination lever, the seatback will return to its first locked position.
The recliner handle will have to be actuated to adjust the seatback to the desired
reclined position.
• The front passenger seats have a track memory which returns the seat to just past the
halfway point of the track, regardless of its original position.
• The recliner and easy entry levers should not be used during the automatic returning of
the seat to its fully upright position.
WARNING!
• Adjusting a seat while the vehicle is moving is dangerous. The sudden
movement of the seat could cause you to lose control. The seat belt might not
be properly adjusted, and you could be severely injured or killed. Only adjust a
seat while the vehicle is parked.
• Do not ride with the seatback reclined so that the seat belt is no longer resting
against your chest. In a collision, you could slide under the seat belt and be
severely injured or killed. Use the recliner only when the vehicle is parked.
GETTING STARTED
14