beautypg.com

Universal garage door opener (homelink®), Programming homelink, Electronics – Jeep 2011 Patriot - User Guide User Manual

Page 41: Universal garage door opener (homelink

background image

• Press the power door UNLOCK switch to unlock the doors. A single chime will

indicate that programming is complete.

Auto Door Lock

• To have the doors lock automatically when the vehicle’s speed exceeds 15 mph

(24 km/h):

• Enter your vehicle and close all the doors.

• Cycle the ignition switch between LOCK and ON and then back to LOCK four

times, ending up in the LOCK position (do not start the engine).

• Press the power door LOCK switch to lock the doors. A single chime will indicate

that programming is complete.

Sound Horn With Lock

• To turn the horn chirp on or off when the doors are locked:

• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds.

Then, press the PANIC button while still holding the LOCK button.

• Release both buttons at the same time.

Flashing Lights With Lock

• The turn signal lights flashing, when the doors are locked or unlocked, feature can

be turned on or off. To turn this feature on or off:

• Press and hold the UNLOCK button for at least 4 seconds, but no longer than

10 seconds. Then, press and hold the LOCK button while still holding the
UNLOCK button.

• Release both buttons at the same time.

UNIVERSAL GARAGE DOOR OPENER (HomeLink

®

)

Programming HomeLink

®

Begin Programming

• The HomeLink

®

buttons are located in

the overhead console.

• Erase all channels before you begin

programming by holding the two
outside buttons for up to 20 seconds
until the red indicator flashes.

• Park your vehicle outside of the garage and turn the ignition switch to the ON/RUN

position.

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink

®

buttons

while keeping the indicator light in view.

ELECTRONICS

39