beautypg.com

Steering wheel audio controls, Right switch, Left switch – Jeep 2011 Liberty - User Guide User Manual

Page 40: Uconnect™ phone, Phone pairing, Electronics

background image

STEERING WHEEL AUDIO CONTROLS

• The steering wheel audio controls are

located on the rear surface of the
steering wheel.

Right Switch

• Press the switch up or down to

increase or decrease the volume.

• Press the button in the center to

change modes AM/FM/CD/SAT.

Left Switch

• Press the switch up or down to search

for the next listenable station or select
the next or previous CD track.

• Press the button in the center to select the next preset station (radio) or to change

CDs if equipped with a CD Changer.

Uconnect™ Phone

• To determine if your vehicle is equipped with Uconnect™ Phone, press the

Uconnect™ Phone button

. If your vehicle has this feature, after a couple

seconds you will hear a voice prompt. If not, you will see a message on the radio
“Uconnect phone not available”.

• The Uconnect™ Phone is a voice-activated, hands-free, in-vehicle communications

system with Voice Command Capability (see Voice Command section).

• The Uconnect™ Phone allows you to dial a phone number with your mobile phone

using simple voice commands.

• For vehicles equipped with Video Entertainment System (VES)™, refer to the

Uconnect™ Phone section of the Uconnect™ User's Manual on the DVD for further
details.

• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the

DVD for further details.

NOTE: The Uconnect™ Phone requires a mobile phone equipped with the Bluetooth

®

Hands-Free Profile, Version 0.96 or higher. For Uconnect™ customer support, call
1–877–855–8400 or visit www.jeep.com/uconnect.

Phone Pairing

NOTE: Pairing is a one-time initial setup before using the phone. You will also need to
follow the Bluetooth

®

instructions in your cell phone user guide to complete the phone

pairing setup.

• Press the Phone button

to begin.

• Wait for the “ready” prompt and BEEP.

• (After the BEEP), say “Uconnect setup”.

ELECTRONICS

38