beautypg.com

Making a phone call, Phonebook edit, Receiving a call – accept (and end) – Jeep 2011 Grand Cherokee - User Guide User Manual

Page 48: Mute (or unmute) microphone during call, Transfer ongoing call between handset and vehicle, Changing the volume, Electronics

background image

• (After the BEEP), say “phone pairing”.
• (After the BEEP), say “pair a phone”.
• Follow the audible prompts.
• You will be asked to enter a four-digit Personal Identification Number (PIN), which you

will later need to enter into your mobile phone. You can enter any four-digit PIN. You
will not need to remember this PIN after the initial pairing process.

• You will then be prompted to give the phone pairing a name (each phone paired

should have a unique name).

• Next you will be asked to give this new pairing a priority of 1 thru 7 (up to seven

phones may be paired); 1 is the highest and 7 is the lowest priority. The system will
only connect to the highest priority phone that exists within the proximity of the vehicle.

Making A Phone Call

• Press the Phone button

.

• (After the BEEP), say “dial” (or “call” a name).
• (After the BEEP), say number (or name).

Phonebook Edit

• Press the Phone button

.

• (After the BEEP), say “phonebook”.
• (After the BEEP), say “new entry” or “list names” or “delete”.
• Follow the prompts.

Receiving A Call – Accept (And End)

• When an incoming call rings/is announced on Uconnect™, press the Phone

button

.

• To end a call, press the Phone button

.

Mute (Or Unmute) Microphone During Call

• During a call, press the Voice Command button

.

• (After the BEEP), say “mute” (or “mute off”).

Transfer Ongoing Call Between Handset And Vehicle

• During a call, press the Voice Command button

.

• (After the BEEP), say “transfer call”.

Changing The Volume

• Start a dialogue by pressing the Phone button

, then adjust the volume during a

normal call.

• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable

level while the Uconnect™ system is speaking. Please note the volume setting for
Uconnect™ is different than the audio system.

NOTE:

To access the tutorial, press the Uconnect™ hard-key. After the BEEP, say “tutorial”.

Press any hard-key/button or touch the display (Touch-Screen radio) to cancel the tutorial.

ELECTRONICS

46