Accessory positions with engine off, Theft alarm, To arm – Jeep 2011 Grand Cherokee - User Guide User Manual

Page 14: To disarm, Getting started

Accessory Positions with Engine Off

NOTE:

The following functions are with the driver’s foot OFF the Brake Pedal

(Transmission in PARK or NEUTRAL Position).

Starting With The Ignition Switch In The OFF Position:

• Press the ENGINE START/STOP button once to change the ignition switch to the ACC

position.

• Press the ENGINE START/STOP button a second time to change the ignition switch to

the ON/RUN position.

• Press the ENGINE START/STOP button a third time to return the ignition switch to the

OFF position.

NOTE:

If the ignition switch is left in the

ACC or ON/RUN (engine not running)
position and the transmission is in PARK, the
system will automatically time out after
30 minutes of inactivity and the ignition will
switch to the OFF position.

THEFT ALARM

To Arm

• Keyless Enter-N-Go button installed: Press the Keyless Enter-N-Go Start/Stop

button until the Electronic Vehicle Information Center (EVIC) indicates that the vehicle
ignition is “OFF”. Press the power door lock switch while the door is open, press the
Key Fob LOCK button, or with one of the Key Fobs located outside the vehicle and
within 5 ft (1.5m) of the driver's and passenger front door handles, press the Keyless
Enter-N-Go LOCK button located on the door handle.

• Keyless Enter-N-Go button not installed: Turn the ignition switch to the

“OFF” position. Press the power door lock switch while the door is open, press the Key
Fob LOCK button, or with one of the Key Fobs located outside the vehicle and within
5 ft (1.5m) of the driver's and passenger front door handles, press the Keyless
Enter-N-Go LOCK button located on the door handle.

NOTE:

After pressing the Keyless Enter-N-Go LOCK button, you must wait 2 seconds

before you can lock or unlock the vehicle via the door handle.

To Disarm

• Keyless Enter-N-Go button installed: Press the Key Fob UNLOCK button or

with one of the Key Fobs located outside the vehicle and within 5 ft (1.5m) of the
driver's and passenger front door handles, grab the Keyless Enter-N-Go door handle
and enter the vehicle, then press the Keyless Enter-N-Go Start/Stop button (requires at
least one valid Key Fob in the vehicle).

• Keyless Enter-N-Go button not installed: Press the Key Fob UNLOCK button

or with one of the Key Fobs located outside the vehicle and within 5 ft (1.5m) of the
driver's and passenger front door handles, grab the Keyless Enter-N-Go door handle
and enter the vehicle, then turn the ignition to the ON/RUN position.

OFF

RUN

ACC

Press

GETTING STARTED