beautypg.com

Rear seats, 60/40 split rear seat, Heated/ventilated seats – Jeep 2011 Grand Cherokee - User Guide User Manual

Page 21: Front heated seats, Front ventilated seats, Getting started

background image

REAR SEATS

60/40 Split Rear Seat

To Lower Rear Seatback

• With the front seats fully upright and

positioned forward, pull upward on the
release lever and fold the rear seatback
down.

To Raise Rear Seatback

• Raise the rear seatback and lock it into

place.

To Recline Rear Seatback

• To recline the seatback, lean forward before lifting the handle, then lean back to the

desired position and release the handle. Lift the handle to return the seatback to an
upright position.

HEATED/VENTILATED SEATS

Front Heated Seats

• The controls for front heated seats are

located near the bottom center of the
instrument panel (below the Climate
Controls).

• Press the switch once to select High-level

heating. Press the switch a second time
to select Low-level heating. Press the
switch a third time to shut the heating
elements Off.

• If the High-level setting is selected, the system will automatically switch to Low-level after

approximately 55 minutes. The Low-level setting will turn Off automatically after
approximately 45 minutes.

Front Ventilated Seats

• Located in the seat cushion and seatback are small fans that draw the air from the

passenger compartment and blow air through fine perforations in the seat cover to
help keep the driver and front passenger cooler in higher ambient temperatures.

• There are two ventilated seat switches that allow the driver and passenger to operate the

seats independently. The ventilated seat switches are located on the switch bank in the
center stack of the instrument panel, just below the climate controls. The ventilated seat
switches are used to control the speed of the fans located in the seat. Press the switch
once to choose HIGH, press it a second time to choose LOW. Pressing the switch a third
time will turn the ventilated seat OFF. When HIGH speed is selected both lights on the
switch will be illuminated. When LOW speed is selected one light will be illuminated.

GETTING STARTED

19