Jeep 2005 Liberty - Manual (Page 143)

If the message TRANSMIT appears on the HomeLink
display but your device does not activate, the device may
be equipped with a
Љrolling codeЉ system. Continue with
steps five through seven below to complete the program-
ming of a rolling code equipped device (most commonly
a garage door opener).
5. At the garage door opener receiver (motor-head unit)
in the garage, locate the
ЉlearnЉ or ЉsmartЉ button. This
can usually be found where the hanging antenna wire is
attached to the motor-head unit.
6. Firmly press and release the ЉlearnЉ or ЉsmartЉ button.
(The name and color of the button may vary by manu-
facturer.)
NOTE: There are 30 seconds in which to initiate the next
step.
7. Return to the vehicle and firmly press, hold for two
seconds and release the programmed HomeLink button.
Repeat the
Љpress/hold/releaseЉ sequence a second time,
and, depending on the brand of the garage door opener
(or other rolling code equipped device), repeat this
sequence a third time to complete the programming
process.
HomeLink should now activate your rolling code
equipped device.
NOTE: To program the remaining two HomeLink but-
tons, simply repeat the ЉProgramming HomelinkЉ pro-
cess.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 143
3