Jeep 2004 Liberty - Manual (Page 257)

• This device must accept any interference received,
including interference that may cause undesired op-
eration.
The tire pressure sensors are covered under one of the
following licenses:
United States . . . . . . . . . . . . . . . . . . . . . KR5S120123
Canada . . . . . . . . . . . . . . . . . . . . . . . . 2671-S120123
TIRE CHAINS
CAUTION!
To avoid damage to your vehicle or tires, observe the following
precautions:
•
Because of restricted chain clearance between tires and other
suspension components, it is important that only chains in
good condition are used. Broken chains can cause serious
damage. Stop the vehicle immediately if noise occurs that could
indicate chain breakage. Remove the damaged parts of the
chain before further use.
•
Install chains on the rear wheels as tightly as possible and then
retighten after driving about
1 ⁄ 2 mile (0.8 km).
•
Do not exceed 30 mph (48 km/h).
•
Drive cautiously and avoid severe turns and large bumps,
especially with a loaded vehicle.
•
Do not drive for prolonged period on dry pavement.
•
Observe the tire chain manufacturer’s instructions on the
method of installation, operating speed, and conditions for use.
Always use the lower suggested operating speed of the chain
manufacturer if different than the speed recommended by the
manufacture.
STARTING AND OPERATING 257
5