Jeep 2004 Liberty User Manual

Page 15

NOTE:

• The Sentry Key Immobilizer System is not compatible

with remote starting systems. Use of these systems
may result in vehicle starting problems and loss of
security protection.

• Mobil Speedpass™, additional Sentry Keys, or any

other transponder equipped components on the same
keychain will not cause a key-related (Transponder)
fault unless the additional part is physically held
against the ignition key

being used when starting the

vehicle. Also, cell phones, pagers, or other RF electron-
ics will not cause interference with this system.

All of the keys provided with your new vehicle have
been programmed to the vehicle electronics.

Important Note About Service

A four digit PIN number is needed to service the Sentry
Key Immobilizer System. This number can be obtained
from your authorized dealer. However, this number can
also be found on your customer invoice that you were
given upon receipt of your vehicle.

Replacement Keys

NOTE:

Only keys that have been programmed to the

vehicle electronics can be used to start the vehicle. Once
a Sentry Key has been programmed to a vehicle, it cannot
be programmed to any other vehicle.

At the time of purchase, the original owner is provided
with a four digit PIN number. This number is required
for dealer replacement of keys. Duplication of keys may
be performed at an authorized dealer or by using the
Customer Key Programming procedure. This procedure

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE