Chief Manufacturing PSH-2000 - Manual (Page 7)

Installation Instructions Model: PSH-2000
7
INSTALL STATIC BRACKETS
AKIRA 84", ORION 84", AND MODULAR 84"
DISPLAYS
1. Using key (150), loosely install brackets (20) to plates
(10) with screws (130) (See Figure 10). Ensure the
following:
•
Brackets (20) are installed to outside set of
mounting holes, closest to supports (30).
• Brackets (20) are installed so that latches (40) are
towards top of mount.
2. Tighten all 16 screws (130) securely.
Figure 10: Installation on Outside Mounting Holes
OTHER LARGE FLAT PANEL DISPLAYS
1. Determine horizontal dimension between mounting
buttons on back of display (or interface bracket, if
required) (See Figure 11).
Figure 11: Horizontal Dimension
2. Using key (150), loosely install brackets (20) to plates
(10) with screws (130) according to dimension noted
in previous step. Ensure that brackets (20) are
installed so that the latches (40) are towards the top
of the mount.
• 14" horizontal dimension: Install brackets (20) to
inside set of mounting holes, closest to center of
mount (See Figure 12).
• 24" horizontal dimension: Install brackets (20) to
middle set of mounting holes (See Figure 13).
• 33" horizontal dimension: Install brackets (20) to
outside set of mounting holes, closest to supports
(30) (See Figure 10).
3. Tighten all 16 screws (130) securely.
Figure 12: Installation on Inside Mounting Holes
Figure 13: Installation on Middle Mounting Holes
(130)
(16 Places)
Mounting Buttons
(6 buttons shown;
4 buttons similar)
Back of Display
(130)
(16 Places)
(130)
(16 Places)