Home Legend Solid Click - Manual (Page 6)

Doc. ID: 127 Rev: 2 Effective: 2/24/2014 Page | 6
Step 2 – Install the Second and Remaining Rows
• Cut off section of the first plank lengthwise to ensure 6” joints staggering.
• Hold the plank with the tongue facing the previous row. Keep it at about 30° angle.
• Insert the tongue into the groove.
• Make sure the tongue are snuggly and securely engaged in the groove by exerting a constant pressure in the direction of the groove.
• Maintain the pressure while pressing the plank flat to lock the edge joints.
• If there is a slight gap along the edge joints, it can be eliminated with the help of a tapping block and a plastic mallet. Be careful to
prevent impact damage while doing it.
Step 3 - Install the Last Row
• Use the pull bar to draw the last row to fit tightly to the previous row.
Glue Down Installation
PLEASE NOTE:
ANY EXCESS GLUE WHICH GETS ONTO THE SURFACE OF THE FLOOR MUST BE REMOVED IMMEDIATELY WITH ADHESIVE REMOVER
The steps in glue down method are very similar to the floating installation method. The only difference is the application of the glue to the
subfloor prior to installation. For more detail instruction, see the floating installation section above.
Step 1 – Set up
• Cut off the tongue from the long edge of the boards for the first rows.
• Ensure expansion gap by marking off a starting line 1/2” away from the starting wall. Use board or spacers if available during
installation.