Gastroback 40975 Design Hand Blender Advanced Pro User Manual

Page 13

note: Don’t chop extremely hard food, such as ice cubes, nutmeg, coffee

beans and grains.

warnIng:

Always release the ON-button, wait until the motor stops and

unplug the appliance before opening the chopper and taking out the food,

laying down the appliance or assembling/dismantling the min-chopper.
Before connecting the appliance to the mains power supply, always ensure

that the appliance is assembled correctly, according to the following instruc-

tions. Do not touch the blade of the chopper with your hands or any objects

(i.e. hair, clothes, tissue), when it is mounted and the appliance is connected

to the mains power supply.
1. Prepare your food.

warnIng:

The chopper vessel is not heat resistant. The max. tempera-

ture is 70 degrees. Let the boiling food cool down a little bit before filling it into the vessel.
2.

Ensure, that the appliance is unplugged.

warnIng:

The blade of the chopper is very sharp. Do not touch the

blades. Always handle the tools by the shaft.
3. Place the blade of the chopper on the centre pin of the vessel (see picture

J). Than turn it clockwise to lock it into place. Always place the chopper

vessel on the non-slip-rubber base to avoid injuries.
4. Place the prepared food into the chopper and place the lid onto the vessel

(see picture K). Fill the vessel only up to the 500 ml mark. Place the shaft

of the chopper onto the motor block and press together until it snaps into

place (see picture L, next page). There may be no gap between the motor

housing and the chopper. The blender shaft must be locked firmly and may

not wobble.
5. Choose the speed with the variable control switch.
6. Connect the power plug to a suitable wall power outlet.
7. Hold on to the chopper vessel with one hand and press the ON-button to start the motor.
cauTIOn: Do not use the appliance with the chopper attachment in conti-

nuous operation for more than 1 minute to avoid overheating. If processing

large quantities of food, regularly interrupt the operation and unplug the

appliance for a few minutes, allow the motor to cool down.
8. Chop your food to the desired quality, but at least after 1 minute of conti-

nuous operation release the ON-button.
9. Wait until the motor stops. Always unplug the appliance immediately after

operation or before assembling/disassembling the tools. By pressing both

release-buttons remove the motor block from the chopper attachment and

place the motor block on a suitable surface, where it cannot fall.

warnIng:

Always release the ON-button, wait until the motor stops

completely and unplug the appliance before assembling or dismantling the

tools.