Gastroback 41006 Design Mixer Advanced Pro User Manual

Page 19

safe. The lid, inner lid, blade assembly housing may be washed in the dishwasher in the top

shelf only on a standard wash. The blender jug may be placed in the bottom shelf.

Disassembling the blender jug and removing stubborn residues
wARning:

The blade is very sharp! Do not touch the blade. To handle the blade, always

hold on to the blade assembly housing.
1.

Take the blender jug off the motorblock and hold it over the sink. Remove the blade assem-

bly housing turning it clockwise. Take the blade assembly housing off the blender jug.
ATTenTion: The blender jug might be connected really tight to the holder. Do not use force

unscrewing it.
2. Rinse all units in warm soapy water. Soak stubborn residues for a few minutes and then

remove them using a nylon washing brush or sponge. Do not cut yourself. Beware not to dam-

age the sealing ring. If you can not get the sealing ring clean or if it is porous or damaged

you have to replace it. Contact your vendor for replacement units.
3.

After cleaning rinse all parts with clear water and dry them carefully. You can also leave

all parts dry naturally where they are out of reach of young children. When the units are dry

assemble the blender jug for storage or usage.

cleaning the motor block
wARning:

Do not place the appliance in an automatic dishwasher or pour boiling

water over it. Do not immerse the motor or power cord in any liquids or spill any liquids on it

or place the motor on wet surfaces. Always wipe off spilled liquids immediately. Ensure that

no water can run into the louvre. When liquids are spilled on the motor housing, immediately

unplug the appliance and dry the motor housing to avoid risk of electric shock or fire. Do not

attempt to operate the appliance, when liquids are on or in the motor housing.
1. Always turn the appliance ›Off‹, wait for the motor to stop completely, and unplug the

appliance from the power outlet before you start cleaning the motorblock.
2. Wipe the motor housing and power cord with a damp soft cloth. Take care not to spill or

drip water or any other liquids on the motor housing.
ATTenTion: Ensure not to damage the drive gear. Never poke with anything into the motor-

block. If necessary use a soft brush for cleaning. If any liquids run into the motorblock clean

and dry the motorblock very carefully.
3.

Thoroughly dry the motor housing after each cleaning or leave it dry naturally where it is

out of reach of young children. Afterwards assemble the appliance.
Attendance: You do not need to oil the motor. Clean the units only as described in the

instructions.

wARning:

Return the entire appliance (including all parts and accessories) to an author-

ised service centre for examination and repair.