Care and cleaning – Gastroback 41006 Design Mixer Advanced Pro User Manual

Page 18

ingredients close the refill aperture, place the blender jug on the motorblock and make sure it

is securely locked. Turn ›On‹ the appliance pressing the desired function button. Process until

the food has the favoured texture.
7. Turn the appliance ›Off‹ (all buttons illuminations will go out) as soon as you are done with

operating and take the blender jug off the motorblock. You can pour out liquid foods.
imPoRTAnT: Do not leave any food dry on the surfaces of the appliance. Always clean the

appliance right after use (see ›Care and cleaning‹).
imPoRTAnT: When liquids are spilled on the motor housing, immediately unplug the appli-

ance and dry the motor housing to avoid risk of electric shock or fire. Do not attempt to

operate the appliance, when liquids are on or in the motor housing.

cARe AnD cLeAning

wARning:

To avoid injury to persons and damage, always turn the appliance ›Off‹, wait

for the motor to stop completely and unplug the appliance, immediately after operation and

before assembling/disassembling or cleaning the appliance.

wARning:

Ware oven gloves if processing hot food. Ensure not to get burned on spilled

over liquids or steam.
ATTenTion: Do not use abrasive cleaners, cleaning pads, corrosive chemicals (disinfectants,

bleach) or any sharp or hard objects (i.e. metal scouring pads) for cleaning, for this could

damage the surfaces. Always handle the entire appliance with care and without violence.

cleaning the blender jug

Empty the blender jug and rise it with warm water.

Fill the blender jug with warm soapy water. The water level should be high enough to cover

the blade with water but not too high to avoid run over liquids. Close the lid. Replace the

blender jug on the motorblock and ensure it is securely locked into position.
3.

Turn ›On‹ the motor on using the Blend function. Let the motor run for a few seconds.

4. Turn the motor ›Off‹ (all buttons illuminations will go out), wait for the blade to stop moving,
pull the plug out of the power outlet and take the blender jug off the motorblock.
5.

Take the lid off the blender jug and pour out the water. Stubborn residues you can remove

using a nylon washing brush or sponge.

wARning:

Pay attention not to cut yourself cleaning around the blade or cleaning the

blade.
imPoRTAnT: The blender jug should be clean now. For the case that there are stubborn

residues on the blender jug or the blade, disassemble the blender jug and clean the single

unit (see ›Assembling and disassembling the appliance‹). Soak the units in warm soapy water.
6.

Clean the lid and the inner lid with soapy water.

Rinse the blender jug, lid, and inner lid with clear water and dry the units thoroughly and

carefully with a cloth or leave all parts dry naturally where they are out of reach of young

children.
note: The blender jug, lid, inner lid, blade assembly housing and silicon seal are dishwasher