Gastroback 41006 Design Mixer Advanced Pro User Manual
Page 11
![background image](/manuals/636680/11/background.png)
49
ing it in position you are able to remove it by turning it clockwise or
anticlockwise.
5. Remove the blade assembly housing by upturning the blender jug
and twisting the Blade Removal System clockwise to unlock (picture C
and D), then lift upwards and away from the base of the blender jug.
ATTenTion: The circular plastic surround attached to the base of the
blender jug is not removable.
ATTenTion: The circular plastic surround attached to the blades is
not removable.
wARning:
The blades are very sharp. Pay attention handling it
and if possible only hold on to the blade assembly housing.
6. Remove the silicon seal from the blade assembly housing for clean-
ing (picture E).
7. Clean the units with a soft sponge in warm soapy water and
dry them off afterwards. Pay attention not cutting yourself handling
the blade. Do not use abrasive cleaners, cleaning pads, corrosive
chemicals (disinfectants, bleach) or any sharp or hard objects (i.e.
metal scouring pads) for cleaning, for this could damage the surfaces.
Always handle the entire appliance with care and without violence.
note: The blender jug, lid, inner lid, blade assembly housing and
silicon seal are dishwasher safe. The lid, inner lid, blade assembly
and silicon seal may be washed in the dishwasher in the top shelf on
low temperature. The blender jug may be placed in the bottom shelf.
Assembling the blender jug
Ensure that the blender jug and all units are clean before you assemble
the appliance.
1. To assemble the blender jug, place the silicon seal onto the blade
assembly housing (picture F). Ensure the sealing ring is in proper posi-
tion and does not fall into the blender jug when attaching the blade
assembly housing to the blender jug. The sealing ring has to be clean
and show no crustifications, crinkles, cracks or look porous.
2.
Hold on to the blade assembly housing with your right hand and
with your left hand hold on to the handle of the blender jug. Upturn the
blender jug and insert the blade assembly housing into the jug base
(picture G and H). The blades have to face inside the blender jug,
when inserting the blade assembly. Twist the Blade Removal System
anticlockwise until firmly locked into position.
wARning:
The blades are very sharp. Pay attention handling it
and if possible only hold on to the blade assembly housing.
note: Ensure the blade assembly housing is securely locked onto the
jug base.
pic C
pic D
pic E
pic F
pic G
Abb H