Gastroback 40118 Easy Juicer - Manual (Page 5)

5
• The feed chute is designed exceedingly large.
Never put fingers, wooden spoons or other
foreign substance (such as hair, clothing,
brushes, cloths) into the feed chute when
the appliance is plugged into the power point.
• Always turn the appliance off, wait for the
motor to stop moving and then pull the plug
before taking off the lid of the juicer.
• Only use the provided food pusher to push
food through the feed chute.
• Never hold your face or other body parts
over the feed chute when the motor is running
because little pieces of food could be thrown
out of the feed chute.
• The blades on the base of the stainless steel
micro mesh filter and inside the feed chute
are very sharp. Pay attention when handling
the units. Only touch the stainless steel micro
mesh filter on the edge and handle with care when
cleaning with the nylon bristle brush. Only store
the appliance completely assembled. This way
the blades will be out of reach.
• Never put foreign substance or hard objects
into the feed chute. Remove all
inedible parts (such as stem, hard peeling
Do not use the appliance in moving vehicles or
boats. Do not use the appliance outdoors.
• The work space has to be easily accessible,
solid, even, dry and of sufficient size.
• Do not use the appliance in moist and wet
areas.
• Do not put any cloth or napkins underneath
the appliance to avoid endangering by fire and
electric shocks.
• Never situate the appliance close to the
edge of the working area.
and seeds) of the food before putting
them into the feed chute.
• The motor pursues running for a little while
after turning the appliance off. Wait until the
motor stops running completely before you
open or move the appliance.
Movable and sharp-edged units – risk of injury
• Never leave the appliance unattended,
when the plug is plugged into the power
point.
• Always turn the appliance off and pull the
plug when the appliance is not in use or
when disassembling, moving or cleaning
the appliance.
• Make sure that the appliance is turned off
before pulling the plug out of the power
point.