CLIFFORD Remote Start & Security System 520.4X - Manual (Page 35)

32 © 2011 Directed Electronics. All rights reserved.
7. The engine turns off and after a few seconds, the Remote Start
LED and Off tones play to confirm. If the door is opened in Step
3 then the engine continues to run.
Turbo Timer Mode
The system keeps the engine running for the Turbo Timer runtime and
can be activated by remote control or optional dash mounted activa-
tion button.
1. With the engine running, set the parking brake.
2. Press the optional dash mounted activation button or perform the
Timer Mode command.
3. The parking lights turn on and the remote start activates the igni-
tion outputs. The Remote Start LED and On tones play to con-
firm.
4. Turn Off and remove the key from the ignition switch, the engine
remains running.
5. Exit the vehicle, close all the doors and arm the system.
6. The engine runs for the Turbo Mode runtime.
Note Turbo Timer must be turned on by an authorized Directed
dealer.
Remote Start Faults
For user safety, the system must be properly configured or remote start
will not activate. The Remote Start Fault output (
LED on and long
fault tone) may be caused by any of several configuration issues. Refer
to the following table for the command type and parking light flashes
that will identify the configuration issue and solution.