ETS-Lindgren HI-3627 ELF Magnetic Field Meter - Manual (Page 13)

HI-3627 Manual Page --5
3.0 Operation
Introduction
This section defines and describes all controls, indicators and
connectors. Refer to figure 3-1 for the location of the
components.
For experienced users or others who particularly dislike reading
explanations of operation, the following is a quick start section
that gets you up and running as quickly as possible.
Quick Start
To be brief, follow these steps:
Step 1. Plug sensor into multi-pin connector at top end of the
meter.
Step 2. Turn the meter on by rotating the range selector
switch one position clockwise. Note: the battery low
LED will flash momentarily as the meter is turned on.
Step 3. Verify that the over range LED and the battery LED are
not illuminated.
Step 4. Make measurements with the range selector switch
set for the maximum reading without an over range
indication.
Controls, Indicators and Connectors
The HI-3627 is housed in a rugged aluminum case with a
detachable probe. The unit is shipped in a convenient carrying
case with foam cutouts which accommodate the meter, probe
and the optional accessories offered with the meter.