Cisco 3515 MCU12 - Manual (Page 34)

2-12
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
OL-11897-01
Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU
Video Processing Module Initial Configuration for the 3515 MCU
Changing Advanced Configuration Settings
You can use the serial port to change the following advanced configuration settings:
• Web server port (for future use)
• Restore factory configuration (for future use)
• LAN port settings
• Disable DSP reset
Procedure
Step 1 At the prompt, enter A to access the Advanced Configuration menu.
The Advanced Configuration menu appears as follows:
Advanced configuration menu
Q: Quit
1: Configure web server port
2: Restore factory configuration
3: Change Lan port Settings
4: Disable DSP reset
Select:
Step 2 At the prompt, enter 1 to configure the web server port.
The current web port server setting displays.
Step 3 At the prompt, enter 2 to restore the factory configuration settings.
You are asked to confirm your choice as follows:
Select: 2
Are you sure you want to restore factory configuration? [y, n]:
Step 4 Enter y or n.
Step 5 At the prompt, enter 3 to change Ethernet speed and duplex parameters.
The network interface card settings screen appears as follows:
Choose : 1 - 10Mbps Half Duplex
: 2 - 100Mbps Half Duplex
: 3 - 10Mbps Full Duplex
: 4 - 100Mbps Full Duplex
: 5 - Auto
other - Quit
:
Step 6 Enter either a number between 0 and 5 inclusive, representing the required option.
Step 7 Press any other key to quit without changing the network working mode.
Step 8 At the prompt, enter 4 to disable the DSP reset facility.
Note After options Q and 1-3, press any key to return to the video processing module Main menu. After option
4, the video processing module Main menu displays automatically.
Caution Only qualified technical personnel should modify the DSP reset function settings.