Dyras HTA-350B User Manual
Page 5

EN
HTA-350B
HTA-350B
8
9
• You must not disassemble the appliance, remove its cover or to try to repair it. Ignoring
this advice could cause a serious accident. There are no parts in the appliance that can
be repaired at home or used for any other purpose. Never operate the appliance with a
damaged mains cable or connector. Do not use the appliance if it fails to work normally or
if it has been dropped or damaged. If the appliance becomes faulty for any reason or if any
moisture is allowed inside, take it to an authorised service engineer for checking and repair.
Only service engineers who have been trained and approved should repair the appliance.
The manufacturer cannot take any responsibility for unauthorised repairs or for any
circumstances resulting from not following the instructions.
Never use the appliance in the bath, in the shower or above a basin containing
any water because of the risk of electric shock. Keep at least one metre from those
situations and any other objects containing liquid when using the appliance. We
strongly recommend that you avoid using the appliance in the bathroom and any
other humid or potentially hazardous place. If the appliance is dropped into water,
immediately disconnect it from the mains. Do not attempt to remove it or touch the
water until the power has been switched off. If the appliance has been dropped into
water or been in contact with high levels of humidity, take it to an authorised service
engineer and have it checked before using it again.
• Before using the appliance in a bathroom, provide extra protection by installing an
additional current safety switch (RCD) with a maximum sensitivity of 30 mA into the
bathroom’s mains supply. A qualified electrician must perform this installation.
• Do not cover the appliance with anything when it is switched on or when it is cooling down.
• Take care not to let any aerosol spray inside the appliance.
• Warning! Some parts of the device become hot during use. In order to prevent burns, take
care not to touch these hot parts and do not put them in contact with scalp.
• Do not use the device on wet hair! For optimum results, hair must be slightly damp but dry
enough to prevent water penetrating the device.
• This appliance is only for styling human hair. It must not be used on animal hair or artificial
hair.
Please keep this instruction manual. If you give the appliance to anyone else, you
must give them this instruction manual, too!
MAIN COMPONENTS
1. Grip
2. Mains switch
3. Hair styling brush
4. Hair styling brush release button
5. Hanging flap
6. Power cable and plug (not shown in figure)
POWER SUPPLY
The device must only be plugged into an electric mains supply of 220 to 240 VAC,
50/60 Hz. Always check that the site voltage is identical to that indicated on the
device nameplate.
USING OF APPLIANCE
Before use
• Unpack the appliance and remove all the packing materials.
• Carefully check the appliance to ensure it is complete and undamaged. You should only use
the appliance if it is complete and has not suffered any damage.
Hair Styler Usage
1. Comb hair out well before styling and partly dry it with a hair dryer. For optimum results,
hair must be slightly moist but dry enough to prevent water penetrating the device.
2. Connect the hair styler to the wall socket then switch it on. Level 1 operation is low power,
level 2 is high power. Position C blows cold air.