Dyras RAR-480 - Manual (Page 5)

RAR-480
8
EN
RAR-480
9
Hanging loop
By storing the hair dryer on the loop you can save space while always having the appliance at hand.
MAINTENANCE AND CLEANING
Warning! Before you clean the appliance it must be switched off and the mains plug must be
removed from the wall socket.
Attention! When cleaning the appliance do not immerse it in water or hold it under
running water.
1. To clean the handle, wipe it with a soft cloth that’s been moistened with a few drops of mild detergent. Next,
remove the detergent by wiping with a soft lint-free cloth moistened with lukewarm water. Finally, wipe the
cleaned surfaces with a dry lint-free cloth. Take care to ensure no moisture enters the appliance. Make sure
the hair straighteners are completely dry before using them again.
2. Never use solvent to clean the appliance (acetone, benzene, gasoline, alcohol, etc.) because these could
dissolve the material of the casing or get inside the appliance damaging the inner parts. Do not use rough or
abrasive cleaning agents.
3. From time to time remove the hair collected at the air suction holes with a brush or a hoover.
4. If you will not use the hair dryer for a longer period after cleaning it, put it in a nylon bag and store at a dry
and dust free place.
QUALITY CERTIFICATION
We hereby certify that dyras RAR-480 type hair dryer complies with the technical parameters listed below:
Type: RAR-480
Description: Professional Styling hair dryer
Nominal network voltage: 230 V, ~ 50 Hz
Network power consumption: 1800 W
Noise emission: L
WA
= 85 dB
Shock protection class: II class
Manufacturer: The dyras wwe.factory U.S.A.
We are continuously developing our products to keep them up-to-date, which means the technical data of our appliances may change without
any prior notice. Errors and omissions excepted.
POWER SUPPLY
The appliance must only be connected to mains electricity of 230V and 50Hz. Always ensure
the mains voltage where you’re using the appliance corresponds to the value shown on the
nameplate of the appliance.
USING OF APPLIANCE
Unpack the appliance and remove all the packing materials.
Inspect the appliance and the accessories carefully to verify their soundness and undamaged condition. Only
perfectly sound and damage-free appliances may be connected to the electrical mains.
The construction of the hair dryer allows fast, effective hair drying and hair styling as well; at the same time the
appliance operates with low noise. The following useful features and accessories make for a comfortable use
Sliding switch to regulate air flow and temperature (control 4)
The sliding switch has 3 settings: Air flow speed can be adjusted in the following ways:
Sliding switch setting Operating mode Power
0. Turned off -
1. Medium air flow 900 W
2. Strong air flow 1800 W
Cool shot snap switch ( )
When pressing the snap switch the dryer will blow mild air instead of the original high temperature air. This
function makes for comfortable use, especially for those with sensitive skin where hair is dried with the original
high air temperature, while the skin surface (brows, temple and the skin around the ears, etc.) could be dried with
mild air temperature. To make use of this function, the snap switch must be pressed down continuously. When
the snap switch is released, the dryer will continue to operate with the air temperature set previously.
Diffuser attachment
The diffuser attachment can be snapped on demand. With it the drying air can reach between the strands
reducing the strain on the outer strands caused by drying and the time necessary to dry the hair. The use of the
diffuser enhances the vitality and natural look of the hair making it voluminous and easy to style.
Concentrator attachment
The concentrator attachment can be snapped on demand. It can be rotated 360 degree to blow concentrated air
to the required place to dry the hair properly.
User'sManual for RAR-480.indd 8-9 User'sManual for RAR-480.indd 8-9 2011.02.08. 19:11:57 2011.02.08. 19:11:57