Quality certification, Copyright, The ce symbol – Dyras SMB-488 User Manual
Page 6: Maintenance and cleaning

QUALITY CERTIFICATION
We hereby certify that dyras SMB-488 type massage and sauna belt complies with the technical
parameters listed below:
Type: SMB-488
Description:
Massage and sauna belt
Nominal voltage
12V DC
Power: 24W
Power adapter nominal network voltage:
100-240V, ~ 50Hz
Shock protection class of the sticking surface:
II class
Manufacturer:
The dyras wwe.factory U.S.A.
We are continuously developing our products to keep them up-to-date, which means the technical data of our appliances may change without
any prior notice. Errors and omissions excepted.
COPYRIGHT
© Copyright The dyras wwe.factory LLC, U.S.A.
All rights - including distribution by film, radio or television, translation, photographic or audio copying, abstract
reprint and other duplication - are specifically reserved. Any breach may result in legal action.
THE CE SYMBOL
This appliance meets the requirements for safety and electromagnetic compatibility (EMC).
The relevant ‘CE’ mark can be found on the nameplate, on the packing box and in the instruction manual.
EN
SMB-488
11
7. You can switch to eight different massage modes using the “MODE” button on the control unit. Pressing the
button one time will display the current mode and by pressing the button again you can switch between the
different massage modes. Two seconds after you last pressed the button, the remaining minutes will appear
again.
8. To turn the appliance off, press the "POWER/HEAT" button for 2 seconds. Each time you finish using the
appliance, always unplug the power adapter from the mains socket and then clean the appliance as
described in "Cleaning the appliance, maintenance" chapter.
9. When you have finished, dry your body with a towel and wait for about 15 - 20 minutes before eating or
drinking cold juice, bathing or showering. After use you will see that the color of your skin on the body area
treated has changed. This is due to the exposure to high temperature; your skin will return to its normal color
within in a few hours.
When using the appliance make sure that the adapter power cable does
not become taut, and never sit on the control unit.
MAINTENANCE AND CLEANING
Attention! Before beginning to clean the appliance, always turn it off and power
it off by unplugging the power adapter from the mains wall socket. It is important
never to dip any part or component of the appliance in water and not to hold it
under water stream.
•
Clean the outside cover of the appliance with a damp, soft, lint-free cloth and then wipe the cleaned surfaces
with a dry lint-free cloth. Take care not to allow any moisture inside the cover. Let the appliance dry
completely before re-using or storing it.
•
Stretch out the belt on a horizontal surface and let it cool down. When the appliance has cooled down
completely, wipe the belt with a slightly damp cloth. Do not wash the belt with wet cloth, or wash or dry it in
a washing machine. Always wait for the belt to dry completely at room temperature before putting it away.
•
Never use solvents (acetone, benzene, petrol etc.) to clean the appliance because these materials could
dissolve the plastic cover and damage the internal components. Do not use harsh or abrasive cleaning agents.
•
If, after cleaning the appliance, it will not be in use for a long time, put it into a nylon pouch and store it in a
place that is dust, humidity and frost free. Do not fold the appliance tightly, as this may result in damage to
the internal wiring or mechanics.
SMB-488
10
User'sManual for SMB-488:User's Manual for SMB-488 2010.11.30. 15:52 Page 10