Dear customer, Smb-488 – Dyras SMB-488 User Manual
Page 4

•
Don’t place the appliance anywhere it could slide down, fall or be knocked off accidentally.
•
Don't use the appliance in the presence of explosive or inflammable gases, vapours or liquids.
Dear Customer,
All electrical and mechanical equipment needs to be cared for appropriately. It’s important
to note that using or storing the appliance in certain conditions may adversely affect its lifespan
and functionality. Always protect the appliance from the conditions listed below.
Using or storing the appliance in a wet, humid or damp environment can cause:
- deterioration and premature aging of the cover and electric insulation of the appliance,
- premature wearing and aging of the plastic and rubber components,
- rust and corrosion affecting electrical components and metal parts.
Using the appliance in a dusty environment or in the kitchen (where the air may be contaminated
with vapours from cooking oil or grease) can cause:
- greasy dust coatings on the mechanical and electrical elements and the casing of the appliance,
which could result in electrical contact failure or even complete breakdown, and could also
damage the plastic and rubber elements.
Exposure to direct sunshine can cause:
- premature aging of the appliance and deterioration of the plastic and rubber parts,
resulting in a safety risk.
Continuous heavy duty use may cause:
- premature structural wear and tear due to the forced use of the appliance, e.g. damage to the
motor resulting in premature failure as a consequence of the overheating caused by continuous
operation and abrasion,
- wear and tear or failure of the control unit's buttons.
Storing the appliance in a frosty or cold environment can cause:
- plastic and rubber parts to become fragile, resulting in a safety risk,
- rust and corrosion affecting electrical components and metal parts
Direct and indirect heat (e.g. being too close to an oven or a heating appliance) can cause:
- damage, deformation, softening or melting of plastic and rubber parts,
- deterioration of electrical insulation, resulting in a safety risk.
Following the operating instructions and avoiding any of the conditions listed above will help you
increase the lifespan of the appliance. The manufacturer is not responsible if the appliance is stored
inappropriately or contrary to these instructions. You are recommended to have the appliance
serviced regularly by an authorised engineer to keep it working for as long as possible.
•
If your appliance is damaged or operates in an abnormal way, immediately stop using it and take it to an
authorised service engineer for checking, repair or adjustment.
•
The manufacturer is not responsible for any damage that results from overuse, incorrect operation, incorrect
maintenance, neglecting the information given in the instruction manual or normal wear and tear. In
addition, the manufacturer is not responsible for damage caused by any parts of the appliance breaking or
cracking.
•
Must not immerse the appliance in water or any other liquid! If humidity gets into the appliance, it can cause
defects, so do not use it in the bathroom or any other room where there is high humidity.
•
Attention! Should the appliance, despite your caution, fall into water or make contact with humidity in any
other way, please take it to the authorised service station and have it checked by an expert before re-using it!
We have to call your attention to the fact that if the product becomes defective due to environmental effects
like this, it will be considered as improper handling, and the manufacturer's warranty will lapse!
•
Attention! The appliance must not be disassembled, its casing must not be removed, or its repair attempted.
There are no parts inside the appliance that could be home repaired or used for any other purpose. In the
case of any defect of the appliance please have it repaired only by an authorised special service station.
The manufacturer does not undertake any warranty for any improper attempt at repair, or any intervention
performed by unauthorised persons.
Keep your environment clean! After use the appliance cannot be disposed together with solid
residential waste, because it can seriously damage living beings and human health. Please hand
over the appliance - at the end of its lifetime - to a waste disposal facility specializing in collecting
electrical appliances, or to a waste disposal facility performing recycling or environmental friendly
disposal of electrical appliances. In addition please never put spent batteries removed from the
appliance in the household waste, but take them to a collecting point designated for this purpose,
because spent batteries are hazardous waste, they contaminate the environment if they are not
disposed of, collected or destroyed in an environmentally friendly way.
Please keep this instruction manual. If you give the appliance to anyone else,
you must give them this instruction manual, too!
7
SMB-488
EN
6
SMB-488
User'sManual for SMB-488:User's Manual for SMB-488 2010.11.30. 15:52 Page 6