Dyras SC-2050 - Manual (Page 6)

SC-2050
6
• Take special care when filling the water tank; never exceed the maximum mark of the accessory dosing glass.
In order to avoid overfilling always ensure that the water tank is empty, never re-fill the tank during use; wait
until the tank empty.
• The lid of the water tank may only be removed from a disconnected and cooled device. It is prohibited to
remove the safety tank lid of the operating or pressurized device.
• Filling of the water tank may only be performed with an unplugged and cooled device.
• Never tilt the device nozzle more than 45º up or down during use, as hot water can also flow out of the tank
together with the steam.
• The steam jet discharged by the device must not be used for cleaning electrical devices and facilities, even if
they are disconnected. Ensure that no electrical devices are in the vicinity of the steam jet, even accidentally.
• Please store the device and its accessories out of reach of children when not in use.
Dear Customer,
All electrical and mechanical equipment needs to be cared for appropriately. It’s important to
note that using or storing the appliance in certain conditions may adversely affect its lifespan and
functionality. Always protect the appliance from the conditions listed below.
Using or storing the appliance in a wet, humid or damp environment can cause:
- deterioration and premature aging of the cover and electric insulation of the appliance,
- premature wearing and aging of the plastic and rubber components,
- rust and corrosion affecting electrical components and metal parts.
Using the appliance in a dusty environment or in the kitchen (where the air may be contaminated
with vapours from cooking oil or grease) can cause:
- greasy dust coatings on the mechanical and electrical elements and the casing of the appliance,
which could result in electrical contact failure or even complete breakdown, and could also
damage the plastic and rubber elements.
The effects of direct sunlight on the appliance can include:
- accelerated deterioration of the appliance casing and its plastic and rubber components,
damage to strength and other structural features. The appliance’s surface may become porous
and fragile, which may result in a safety risk.
Continuous, industrial use of the device can cause:
- premature structural wearing due to excessive operation, premature wear and damage to the
seals of the boiler and of the safety tank lid due to wear and heat load caused by continuous
operation.