Dear customer, Sbl-220 – Dyras SBL-220 User Manual

Page 4

SBL-220

Dear Customer,

All electrical and mechanical equipment needs to be cared for appropriately. It’s important to
note that using or storing the appliance in certain conditions may adversely affect its lifespan and
functionality. Always protect the appliance from the conditions listed below.

Using or storing the appliance in a wet, humid or damp environment can cause:

- deterioration and premature aging of the cover and electric insulation of the appliance,
- premature wearing and aging of the plastic and rubber components,
- rust and corrosion affecting electrical components and metal parts.

Using the appliance in a dusty environment or in the kitchen (where the air may be contaminated
with vapours from cooking oil or grease) can cause:

- greasy dust coatings on the mechanical and electrical elements and the casing of the appliance,

which could result in electrical contact failure or even complete breakdown, and could also
damage the plastic and rubber elements.

The effects of direct sunlight on the appliance can include:

- accelerated deterioration of the appliance casing and its plastic and rubber components,

damage to strength and other structural features. The appliance’s surface may become porous
and fragile, which may result in a safety risk.

Continuous heavy duty use may cause:

- premature structural wear and tear and premature aging of the motor due to extensive use of

the appliance, resulting from wear and tear and overheating due to continuous use.

Storing the appliance in cold or frosty environment may cause:

- damage to the plastic and rubber components; if they become fragile, this may result in a safety

risk.

- oxidation resulting from condensation, and corrosion of the metal components.

Direct and indirect heat (e.g. being too close to an oven or a heating appliance) can cause:

- damage, deformation, softening or melting of plastic or rubber parts and casing elements, or

deterioration of electrical insulation.

Following the operating instructions and avoiding any of the conditions listed above will help you
increase the lifespan of the appliance. The manufacturer is not responsible if the appliance is stored
inappropriately or contrary to these instructions. You are recommended to have the appliance
serviced regularly by an authorised engineer to keep it working for as long as possible.

Please respect the environment when the appliance reaches the end of its life. Electrical products
must not be disposed of with other residential waste because they can damage the natural world
and may be hazardous to human health. You should dispose of the appliance at an appropriate
recycling site or by using a collection service that specialises in electrical appliances.

consideration the working and shutdown periods specified for the unit.

•

You should only load food into the bowl attachment and remove food from the attachment when it is turned
off and disconnected from the mains electricity supply.

•

You may only connect fully assembled equipment to the mains electrical network. For your protection, the
equipment is supplied with a security system. This prevents the machine from working if any attachment is
not properly fixed onto the engine unit.

• Special

instruction

Attention! This household appliance was designed for intermittent use. After a maximum of 1 minutes of
operation pause for at least 15 minutes, otherwise the appliance could be damaged. The manufacturer
will not be held liable for any failure of the appliance caused by or originating from exceeding the time
established for continuous operation or non compliance with the intervals prescribed for pausing.

If you fail to observe the rules for intermittent use (1-minute operation, 15-minute standstill), or
if you overload the processor with excessive quantities of food above the recommended limits,
the overheating protection system installed on the equipment may turn on. If you experience the
equipment stopping during operation due to any of the above reasons, turn it off by pressing the
off button then unplug the equipment from the wall socket and wait 30 minutes. Following this,
continue operating the equipment following the recommendations for the use of this equipment. If
the equipment does not operate even after the 30-minute standstill period, take it to an authorised
service centre for repair.

•

The manufacturer takes no responsibility for:
- damage caused by excessive stress, unprofessional handling and maintenance, or the non-observance

of the instructions provided in the user’s manual.

- the normal wear of parts, including the wearing of the blades and bearings.

Furthermore, the manufacturer’s warranty does not cover the breaking or cracking of subassemblies
or other parts of the unit.

•

Do not lengthen or alter the mains cable of the appliance. If you need a longer cable between the appliance
and the wall socket, you should buy a standard extension cord from an electrical dealer. When using an
extension cord, be careful not to create a hazard that you or someone else could trip over.

•

You must not disassemble the appliance, remove its cover or to try to repair it. Ignoring this advice could
cause a serious accident. There are no parts in the appliance that can be repaired at home or used for any
other purpose. Never operate the appliance with a damaged mains cable or connector. Do not use the
appliance if it fails to work normally or if it has been dropped or damaged. If the appliance becomes faulty
for any reason or if any moisture is allowed inside, take it to an authorised service engineer for checking and
repair. Only service engineers who have been trained and approved should repair the appliance.
The manufacturer cannot take any responsibility for unauthorised repairs or for any circumstances resulting
from not following the instructions.

User's Manual for SBL-220.indd 6-7

2011.02.15. 13:09:36