Dynojet Snowmobile Dynos: Sled Dyno Hub Replacement - Manual (Page 7)

Document # 98263100 5
Warning: When replacing the Outside Driver Hub, notice a punch
mark on the edge of the hub. This punch mark should
be directly opposite of the alignment hole in the Outside
Driver. Be sure that when you install the new Outside
Driver Hub and Outside Driver that these holes are
directly opposite of each other.
Improper alignment of the outside Driver Hub and Driver
will not allow you to assemble the driver set correctly.
Punch Mark
Be sure that the punch mark and alignment hole are
directly opposite of each other !!
Step 7
Assemble the driver set and then install it on the dyno. If the
driver set is assembled properly, the shafts should slide in
without complication.
• If you have any questions, or need
technical assistance, call (406) 388-5255.