Dynojet 424: Quick start for DWRT OBD2 device User Manual
Obd2 data-link interface user guide

Vehicle Compatibility
OBD2 Data-Link Interface User Guide
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081
1-800-992-4993 www.dynojet.com
D
y
n
o
W
a
re R
T - O
B
D
2 D
a
ta
-L
in
k
A
98200066.01
1. Start the vehicle.
2. Start PowerCore software.
3. Click WinPEP 8 Dyno Control from the Application Launcher.
4. Connect to the DynoWare RT.
5. Click the Configuration tab.
6. Click RPM Configuration.
7. Select OBD2 from the RPM Source drop-down list.
8. Click OK.
OBD2 Configuration
The DynoWare RT OBD2 Data-Link Interface plugs directly into the CAN-based vehicle's OBD2 port and brings data from the vehicle's ECM
directly into DynoWare RT. The OBD2 engine RPM channel can be used as your dyno's primary RPM signal.
Data can be viewed in real-time and saved with the dyno graph.
• All vehicles 2008 and later model year.
• Most post 2003 vehicles that have the OBD2 pins populated for CAN.
• All vehicles manufactured in or imported to North America starting in
the 2008 model year have to be CAN compliant as part of
OBD2 regulations.
Connecting the OBD2
1. Locate the OBD2 port on the vehicle.
2. Connect the Data-Link to the OBD2 port on the vehicle.
3. Connect the OBD2 cable to the Data-Link.
4. Connect the OBD2 cable to the powersports port on the
DynoWare RT main module.
CAN Pin Locations