Dynojet 198: Dyno Drum Cover for Kart and ATV Dyno Motorcycle Option - Manual (Page 3)

Step 3
Use a hammer and a transfer punch to mark the two holes for the
retaining pins. The two holes are opposite of each other and near
the corners.
Step 4
Remove the cover and drill the marks that you made with a 1/4” bit.
Step 5
Replace the cover and line up the holes. Install the push pins
through the cover and into the dyno top deck.
You may now operate the Kart Dyno with the Motorcycle Carriage
Option.
P/N 98230100 3
Mark the two
holes here:
Install the push pins
Note: Never operate a motorcycle on the dyno with
the drum cover removed.