Dave Smith Instruments MOPHO - Manual (Page 23)

allows subtle amounts of frequency drift. For larger amounts, use a random LFO
or white noise mod.
Pitch Wheel Range: 0…12 — Sets the bend range, in semitones, of the pitch
wheel. The setting is the range in the positive or negative direction. For
example, a setting of 7 lets you bend a note up or down by a fifth.
Key Assign: see table — Determines how Mopho responds to keyed notes.
Display Key mode
Low Note Low note priority
LowRetrig Low note priority, re-trigger envelopes
HighNote High note priority
HighRetrg High note priority, re-trigger envelopes
LastNote Last note hit priority
LastRetrg Last note hit priority, re-trigger envelopes
Mixer Parameters
Osc Mix: 0...127 — Enables the outputs of Oscillators 1 and 2 to be mixed in
varying amounts. A setting of 0 is equivalent to 100% Oscillator 1 and 0%
Oscillator 2. A setting of 127 is just the opposite. A setting of 64 is essentially a
50-50 mix of both oscillators.
Noise Level: 0…127 — Controls the volume of white noise mixed into the
filter.
Ext In Volume: 0...127 — Controls the level of external audio input mixed into
the filter. This is used for processing other audio sources (guitars, recordings,
etc.) through Mopho’s analog electronics. This works in conjunction with the
front panel’s I
NPUT
G
AIN
control.
Also, since the left channel of A
UDIO
O
UT
is normalled to A
UDIO
I
N
, this control
sets the amount of Mopho’s audio output returned to the audio input. Use this
for crazy feedback sounds.
Low-pass Filter Parameters
Mopho utilizes a switchable, 2- or 4-pole analog low-pass filter coupled with a
4-stage (plus delay) ADSR envelope generator.
Frequency: 0…164 — Sets the base filter cutoff frequency over more than 13
octaves. This control steps in semitones.
17