Dave Smith Instruments MOPHO - Manual (Page 12)

mode and displays the last parameter edited and its stored and edited values. See
Program Parameters starting on page 15 for more information.
Global mode is accessed by briefly holding down the P
ROGRAM
M
ODE
button.
The Global menu is displayed. Use P
ROGRAM
to change global parameters and
the increment and decrement (+ and -) buttons to change the settings. See Global
Parameters on page 13 for more information.
To return to program mode from edit or global mode, simply press P
ROGRAM
M
ODE
.
Write — Use W
RITE
to save an edited program to any of Mopho’s 384 memory
locations. To execute the write operation, press the increment (+) button. To
cancel a write, press W
RITE
, decrement (-), or P
ROGRAM
M
ODE
. W
RITE
is also
used to execute certain operations in the Global menu.
Note: You can store a program in a different location. After hitting the
W
RITE
button, you can change the destination using the P
ROGRAM
knob,
and you can change banks by holding the increment (+) and decrement
(-) buttons. Be careful changing the banks! If you hit the increment
button quickly, it saves the program wherever you are at that point. If you
want to change banks, just be sure to hold the button for a couple
seconds.
Volume — Controls the volume of the left and right audio outputs and the
headphone output.
Increment/Decrement — The increment and decrement (+ and -) controls are
used to step through programs in program mode, to change values in the Global
menu, and to confirm or cancel various operations. In edit mode they
increase/decrease the parameter value. They are also used to select Mopho’s
three program banks. Hold increment briefly to switch to the next highest bank;
hold decrement to switch to the next lowest bank.
Assignable Parameters 1-4 — Any of Mopho’s program parameters can be
edited from the front panel using the A
SSIGNABLE
P
ARAMETERS
controls and the
assignments for the controls are saved per program, to best suit that program. In
other words, the assignments for the controls can be completely different from
one program to another.
Assign Parameters — When the A
SSIGN
P
ARAMETERS
LED is lit, turn any of
the A
SSIGNABLE
P
ARAMETERS
controls to select from the list of program
parameters. Press A
SSIGN
P
ARAMETERS
again (turn the LED off) to use the
A
SSIGNABLE
P
ARAMETERS
controls to edit the selected parameters. For a
description of the parameters, see Program Parameters beginning on page 15.
For a list of the parameters, see page 29.
6