Copernicus VE550 - Manual (Page 2)

NOTE: Do not tighten any fasteners until the easel is completely assembled
Visit www.copernicused.com to browse our entire line of educational aids
5
6
1
2
3
8
11
7
1 Assemble the Base
2 Install the Book Ledge
- Use 30mm bolts and lock nuts
- Hand tighten only
3 Install the Right Upper Frame
-NOTE: Look for the “R” (right) marking on the frame
-Slide the right frame into the right side of the base
(orientation is based on looking at the easel from the front)
4 Install the Left Upper Frame
5 Install the Lower Cross Bar
- Use 35mm bolts and lock washers
- Hand tighten only
6 Install the Upper Cross Bar and S Hooks
- Slide the S hooks onto the cross bar
- Use 35mm bolts and lock washers
- Hand tighten only
7 Install the White Board to the Upper Frame
- Use 30mm bolts and lock nuts
- Hand tighten only
8 Install the White Board to the Book Ledge
- Use 12mm bolts with lock nuts
- Thread through white board hooks and book ledge
- Hand tighten only
9 Tighten the 4 Casters
- Use the two spanners
10 Tighten all Remaining Fasteners
- Note: 11 in total
11 Install the White Board Chart Paper Hooks
- Place caster washer over threaded caster stem
- Insert the threaded caster stem through a hole in the lower frame
- Thread locking casters in front holes of lower frame
- Thread non-locking casters in back holes of lower frame
- Place the corresponding “eye” of the lower shelf through the stem
- Place flat washer, lock washer and acorn nut on caster stem
- Hand tighten only
- Repeat with other 3 casters
- NOTE: Look for the “L” (left) marking on the frame
- Slide the left frame into the left side of the base
(orientation is based on looking at the easel from the front)
- Fit the hooks over the top edge of the board
- NOTE: Make sure the hooks are in between the white board’s sliding wire loops
(to stop the chart paper hooks from sliding off the edge accidentally)