Copernicus PDR20 User Manual
Warning, Spring loaded drying rack, Assembly

M
y idea of education is to
unsettle the minds of the young
and inflame their intellects.
R
OBERT
M
AYNARD
H
UTCHINS
I
n everyone’s life at some time our
inner fire goes out. It is then burst
into flame by an encounter with
another human being. We should
all be thankful for those people
who rekindle the inner spirit.
A
LBERT
S
CHWEITZER
N
othing has a better effect upon
children than praise.
S
IR
P
HILIP
S
IDNEY
Spring Loaded Drying Rack
x 1
Note: metric hardware
bent feet
x 2
caster stretcher
x 1
hex key
x 1
M8 hex nuts
x 4
2" threaded
stem caster
x 2
2
3
3
1
1
1
1
2
M6 x 45mm (large)
bolt
x 4
M6 lock washer
x 6
M6 (small) hex nut
x 4
M6 x 30 (small) bolt
x 2
PDR20-2008-C
Spring Loaded Drying Rack
Contents of Box
If parts are missing or you experience problems, please call:
1-800-267-8494
Have your packing slip ready for reference
or email [email protected]
Visit
www.copernicused.com
to browse our entire line of educational aids
PDR20-2008-C
October 16, 2008
1 of 1
*Only when total assembly is complete — tighten all bolts.
Assembly:
1.
With rack on it’s
side, bolt the bent
feet to the bottom
of the frame with
the large bolts, lock
washers and nuts
with hex key
included.
2.
Bolt caster stretcher
to the bent feet
using the remaining
two small bolts and
lock washers.
3.
Insert threaded stem
caster, with hex nut
on either side, into
the caster stretcher.
4.
If the rack does not
roll properly, the
caster height can be
changed by
adjusting the nuts.
DO NOT REMOVE THE TIE AROUND RACK
UNTIL FULLY ASSEMBLED
WARNING