Code 3 XT402 & XT602 - Manual

XT402 / XT602 - LED LIGHTS
WIRING INSTRUCTIONS:
To +VDC (fuse @ 3A) ---------------------------------------- RED
To Chassis Ground ------------------------------------------- BLACK
Flash Pattern Select (see list at right) ---------------- BLUE
Connect YELLOW wires of all heads together for
Synchronization ----------------------------------------------- YELLOW
*When the Yellow wires of all heads are connected together, the Group1
heads will flash either in phase (P1) or 180 degrees out of phase (P2)
based on the pattern selected. For example, if the XT3 lights in Group1
have pattern PA1, A1-Five Flash P1 selected and the Group2 heads have
pattern PA2, A2-Five Flash P2 selected, the Group1 / Group2 heads will
flash in a Five Flash Alternating (WIG/WAG) mode.
Mount the XTxxx LED light using the brackets supplied and user supplied
mounting screws. Be sure that the unit is properly fused.
CAUTION: Be certain that you have selected a mounting location that will
not interfer with the deployment of the vehicle’s airbags, does not ob-
struct the driver’s vision and allows safe operation of the vehicle. Check
the chosen mounting location to ensure that the vehicle’s structure and
material is adequate to support the weight of your light.
After the XT402 or XT602 light is securely installed, loosen the adjusting
screws Located on each end and tilt the light to the desired angle. Then
tighten the screws. Turn the light on and check the light from the front or
rear of the vehicle, through the window, to ensure that it is at the most
desirable angle, and that the light is not impeded by any obstacles and/or
window tinting.
FLASH PATTERNS:
P1 five flash alt
P2 five flash sim p1
P3 five flash sim p2
P4 quad flash alt
P5 quad flash sim p1
P6 quad flash sim p2
P7 single flash 75 alt
P8 single flash 75 sim p1
P9 single flash 75 sim p2
P10 single flash 375 alt
P11 single flash 375 sim p1
P12single flash 375simp2
P13quad-squad flash alt
P14quad-squad flashsim
P15modulation flash alt
P16modulation flashsim
P17quad-squad scan
P18steadyburn with 5 single & 1 single
P19steadyburn - 5 single
P20steady burn
P21Cycle Flash - AUTORUN
P22off
To select Flash Pattern briefly touch the ,
BLUE to BLACK wire (Ground):
- less than 1 second for next pattern
- more than 1 second for previous pattern
- more than 5 seconds to turn off
Available Colors - Red, Amber, Blue, White and Green
This Product contains high intensity LED devices. To prevent eye damage, DO NOT stare into
light beam at close range.
WARNING!
!