Code 3 XT310 - Manual (Page 4)

4
Operation Environment
Ambient Temperature: -10 to +45 degrees C
Relative Humidity: 10 to 85%, non-condensing
Adjustment
After the XT310AS light is securely installed, loosen the adjusting screws located on each end and tilt the light
to the desired angle. Then tighten the screws. Turn the XT310AS LED light on and check the light from the front
or rear of the vehicle, through the window, to ensure that it is at the most desirable angle, and that the light is
not impeded by any obstacles and/or window tinting.
Troubleshooting
The XT310AS have been factory tested and approved. If the light fails to work, check the following:
1. Press the Function Switch (User Supplied) to be sure the “Off” pattern is not selected.
2. Remove the fuse from the vehicle fuse box and check to see if it has blown.
XT310AS FLASH PATTERNS
WARNING FLASH PATTERNS
1 OFF
2 INBOARD OUTBOARD(single flash)
3 LEFT RIGHT(single flash)
4 ALTERNATE(single flash)
5 INBOARD OUTBOARD(Double flash)
6 LEFT RIGHT(Double flash)
7 ALTERNATE(Double flash)
8 INBOARD OUTBOARD(Quad Flash)
9 LEFT RIGHT(Quad Flash)
10 ALTERNATE(Quad Flash)
11 SINGLE OUTBOARD
12 DOUBLE OUTBOARD
13 SINGLE INBOARD
14 DOUBLE INBOARD
15 TRIPLE INBOARD
16 SWEEP
17 CYCLE FLASH
TRAFFIC DIRECTION MODES
1 Right
2 Left
3 Center-Out
4 Right Fast
5 Left Fast
6 Center-Out Fast
7 SINGLE INBOARD-1
8 SINGLE INBOARD-1 Fast
9 SINGLE INBOARD Full-1
10 SINGLE INBOARD Full-1 Fast
END HEAD FLASH PATTERNS (60 fpm)
1 Single Flash Alternate
2 Double Flash Alternate
3 Three Flash Alternate
4 Quad Flash Alternate
5 Five Flash Alternate
6 Single Flash Simultaneous
7 Double Flash Simultaneous
8 Three Flash Simultaneous
9 Quad Flash Simultaneous
10 Five Flash Simultaneous