Code 3 XP 9501 - Manual

INSTALLATION SHEET FOR XP9501
The XP9501 is shipped with the mounting foot attached to keep the assembly stable during ship-
ment and to eliminate shipping damage. Remove the lens cover as shown below. Set fasteners
aside.
SCREWDRIVER NO TCH
FO R O PENING LENSES
T16320 - #8 SCREW
T16321 - #8 WASHER
XP9500 TOP LENS
REMOVAL PROCESS
Next, remove the five screws attaching the beacon to the
mounting foot. Set these fasteners aside. Separate the
beacon from the mounting foot.
REMOVE SCREWS TO SEPARATE
LOWER LENS FROM MOUNTING
BRACKET
MOUNTING HOL ES
(HARDWARE NOT PROVIDED)
WRENCH CLEARANCE HOLES
(OTHER SIDE NOT VISIBLE)
Place the mounting foot where it is to be assembled
to the vehicle and mark the locations. The holes are
large enough for 1/4” fasteners (not included). After
the mounting foot is installed, route the cable
through the hole in the foot and reassemble the
beacon to the foot. Assemble the lens cover to the
top to complete the assembly.
Parts List/Data
T51001
Lower Lens
T51011 Upper Lens
S24194 Mounting Foot
call factory for lighthead information
Dimensions
Beacon only: 12.5"W x 7"D x 2.7"H
Beacon w/ foot: 12.5"W x 7"D x 3.9"H