Code 3 Work Light - 9 LED - Manual

920-1005-00 Rev. A
Page 1 of 2
Specifi cations:
Voltage: CW2310: 12-24 VDC
CW2311: 12-24 VDC
Current: CW2310: 5.3 Amps @ 12.8VDC
CW2311: 5.3 Amps @ 12.8VDC
Weight: CW2310: 4.7 lbs.
CW2311: 4.7 lbs.
Lumens: CW2310: 5050(Raw), 3600(Effective)
CW2311: 4950(Raw), 3600(Effective)
Installation:
1. Select a mounting location for the unit on a fl at surface.
Place the unit bracket, fl at side down, on the surface.
2. Use the two circular slots in the bracket to mark the drill
locations for mounting. Drill two 0.397 diameter through holes
(X drill bit) through the mounting surface. Align the base with
the mounting holes, and use 3/8”-16 hardware (include bolts,
fl at washers, lock washers, and nuts) to mount the bracket to
the surface. Position the unit in the horizontal direction, and
tighten both nuts.
3. To position the unit vertically, use a 5/32” hex L-key to
loosen the two screws on each side of the bracket. Tighten
the screws when pivoted properly.
IMPORTANT! Read all instructions before installing and using. Installer: This manual must be
delivered to the end user.
Do not install and/or operate this safety product unless you have read and understand the safety
information contained in this manual.
1. Proper installation combined with operator training in the installation, use, care and maintenance of vehicle equipment accessories is
essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fi re.
4. Proper placement and installation are vital to the performance of this worklamp. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he can
operate the system without losing eye contact with the work area.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the
vehicle operator should ensure the projection of the beam is not blocked by vehicle components (i.e., open trunks
or compartment doors), people, vehicles, or other obstructions.
6. The manufacturer assumes no liability for any loss resulting from the use of this device.
WARNING!
Failure to install or use this product according to manufacturer’s recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
!
Code 3’s CW2310 and CW2311 LED Worklamps feature nine
10-watt LEDs that produce an extremely high-intensity beam as
well as an aluminum heatsink housing, heavy-duty stainless steel
mounting bracket and tough polycarbonate lens to withstand the
most demanding applications. These highly durable worklamps
are designed to perform in the harshest of work environments and
offer all the benefi ts of LED technology including the brightest white
light output, a long, maintenance-free service life and extremely low
current consumption.
SAA
NOTE: Black die cast Aluminum housing gets very hot to the touch after operating constantly for several hours.
Installation and Operation Instructions
CW2310 & CW2311 LED WORKLAMPS