Code 3 WingMan with TriCore or Torus for 2011 Dodge Charger - Manual (Page 4)

4
FIGURE 10 FIGURE 11 FIGURE 12
The bracket fasteners shown in Figure 12 make excellent hard mounting points for radar
guns, video cameras, etc.
Caution: Drilling into the housing of the light bar could damage wiring or other internal
components.
Wiring Instructions
It is advisable to leave an extra loop of cable when installing the light bar to allow for future changes or reinstallations.
Connect the black lead to a solid frame ground (earth), preferably the (-) or ground (earth) side of the battery, and the
power wire to the +12V terminal of the battery. Connect the remaining wires as shown on page 5.
Installation Instructions-Cont.
Step 8 From inside the trunk tighten the (2) 1/4"-20 X 5/8" Phillips Pan Head Screws (see Figure 10).
Step 9 Back inside the rear passenger area of the vehicle push the WingMan back tight against the rear window and tighten the (2) 1/4"-20 X
1/2" Black Zinc Plated Phillips Pan Head Screws that fasten the WingMan Mounting Brackets together (see Figure 11).
Step10 Tighten the (2) 1/4"-20 X 1/2" Black Zinc Plated Phillips Pan Head Screws that fasten the WingMan Mounting Brackets to the
WingMan (see Figure 12).
Step11 Reposition the vehicle's fabric upper trunk liner and replace the Christmas Tree Fasteners.
Note: If the Gasket has wavy areas where it contacts the rear window you can press down firmly all along the rear contour on top of
the WingMan as far back as you can reach to allow the gasket to pop back into shape.
Note: As stated in Step-3 if it is desired that you retain the plastic child restraint covers you will have to trim the covers to clear the
WingMan's Mounting Brackets before re installing the covers.