Code 3 WingMan with TriCore for Dodge Charger - Manual (Page 3)

3
FIGURE 1 FIGURE 2 FIGURE 3
Step 2 From inside and lying face up on the trunk floor, look up at the inner roof of the trunk, locate the holes (see the round and rectangular
holes shown in Figure 4). With a steel scale centered and aligned with the holes, mark the center line as shown in Figure 5. When the center
line is in the correct location it will look as shown in Figure 6.
Installation Instructions
Step 1 Locate and remove the (6) Christmas Tree fasteners (see Figures 1and 2) holding the fiber inner/upper trunk
cover. Remove the fiber inner/upper trunk cover (see Figure 3).
FIGURE 4 FIGURE 5 FIGURE 6
Step 3 Measure 12 inches over from the center line just marked in Step 2 (Figure 6 above) towards the passenger side, make a mark at the
center of the bottom of the indented rectangular area, and drill a 3/8" diameter hole through the sheet metal and the rear deck fabric (as shown
in Figure 7), then measure 12 inches over from the center line towards the driver side, make a mark in the center of the square indented area,
and drill a 3/8" diameter hole through the sheet metal and the rear deck fabric (as shown in Figure 8). The result is two holes that are 24" apart
and located in the approximate center of the two recessed areas of the rear deck sheet metal. Note: Make sure any OEM wiring is out of the
way so you don't damage the wiring when drilling the holes!
Step 4 Enlarge the hole between the vehicle's existing rectangular punched hole and the small plastic fastener as shown in Figure 9 with a 3/8"
diameter drill and drill through the rear deck fabric for the WingMan Power Cable. Note: Again, make sure any OEM wiring is out of the way
so you don't damage the wiring when drilling the holes!
FIGURE 7 FIGURE 8 FIGURE 9