Code 3 Ultra-Lite Strobe Beacon User Manual

Code 3 Lighting

ULTRA-LITE

FIRE-FLASH II

MODEL L1000H

MODEL L9200H

INSTALLATION INSTRUCTIONS - DC Models Only

ULTRA-LITE: Use on 12-48VDC only. Average load current approximately 1A@ 12 vdc.

FIRE-FLASH: Use on 12-24VDC only. Average load current approximately 1.5A@12 vdc.

Red wire is Positive

(+)

Black wire is Negative

(-)

Use fuse loop included for protection. Locate as close to the battery as possible. Failure to
use fuse loop voids warranty. To install fuse loop, cut loop in two and remove one-half inch
insulation from each end. Connect one end to Positive, the other end to the red lead of the

strobe light. Connect black lead to vehicle ground.

REPLACEMENT PARTS LIST

PART NO.

DESCRIPTION

15597

XENON FLASH TUBE

14425

LENS O-RING

13069

LENS RETAINER RING

14428

ALUMINUM CIRCUIT CASE

14533

BASE MOUNTING GASKET

13075

LENS DUST COVER

14429

BRANCH GUARD FOR 4” LENS

14630

BRANCH GUARD FOR 6” LENS

13057

6” AMBER LENS

13058

6” BLUE LENS

13059

6” CLEAR LENS

13060

6” GREEN LENS

13061

6” MAGENTA LENS

13062

6” RED LENS

13063

4” AMBER LENS

13064

4” BLUE LENS

13065

4” CLEAR LENS

13066

4” GREEN LENS

13067

4” RED LENS