Code 3 Ultra-Lite Strobe Beacon Galls - Manual

1
INSTALLATION INSTRUCTIONS
DC Models Only
ULTRA-LITE ® : Use on 12-48VDC only. Average load current approximately 1A@12 vdc.
FIRE-FLASH: Use on 12-24VDC only. Average load current approximately 1.5A@12 vdc.
Red wire is Positive
Black wire is Negative
Use the fuse loop included for protection. Locate as close to the battery as possible. Failure to use
fuse loop voids warranty. To install fuse loop, cut loop in two and remove one-half inch insulation
from each end. Connect one end to Positive, the other end to the red lead of the strobe light.
Connect black lead to vehicle ground.
REPLACEMENT PARTS LIST
PART NO. D E S C R I P T I O N
1 5 5 9 7 XENON FLASH TUBE
1 4 4 2 5 LENS O-RING
1 3 0 6 9 LENS RETAINER RING
1 4 4 2 8 ALUMINUM CIRCUIT CASE
1 4 5 3 3 BASE MOUNTING GASKET
1 3 0 7 5 LENS DUST COVER
1 4 4 2 9 BRANCH GUARD FOR 4” LENS
1 4 6 3 0 BRANCH GUARD FOR 6” LENS
1 3 0 5 7 6” AMBER LENS
1 3 0 5 8 6” BLUE LENS
1 3 0 5 9 6” CLEAR LENS
1 3 0 6 0 6” GREEN LENS
1 3 0 6 1 6” MAGENTA LENS
1 3 0 6 2 6” RED LENS
1 3 0 6 3 4” AMBER LENS
1 3 0 6 4 4” BLUE LENS
1 3 0 6 5 4” CLEAR LENS
1 3 0 6 6 4” GREEN LENS
1 3 0 6 7 4” RED LENS
U LT R A - L I T E ®
MODEL L1000H
FIRE-FLASH II
MODEL L9200H