Code 3 SuperVisor with TriCore for 2011 Caprice - Manual (Page 4)

4
Installation Instructions Cont.
ANGLED
IN THE SLOT
DRILL HOLES
AT THESE
LOCATIONS
NOT CENTERED
IN THE SLOT
WRONG WRONG CORRECT
FIgURE 1 FIgURE 2 FIgURE 3
FIgURE 4 FIgURE 5 FIgURE 6
FIgURE 7
Step-9 While making sure the SuperVisor is centered in the vehicle tighten all of the Black Oxided #8 X 1" Phillips Truss Head Sheet
Metal Screws (see Figures 17, 18, and 19). Tighten each of the screws a little at a time so that they are all tightened somewhat simultane-
ously, this will help keep the SuperVisor centered.
Step-10 While pushing the SuperVisor very tightly up against the headliner, tighten the (2) 1/4"-20 Inner Mounting Bracket screws as
shown in Figure 23 then tighten the (2) 1/4"-20 Outer Mounting Bracket screws as shown in Figure 24. The idea is to slightly crush the
SuperVisor's Sheet Metal Headliner Flange into the vehicle's headliner fabric to prevent light from flashing through into the Driver's eyes.
Note: It is best to have an assistant push up on the SuperVisor while you tighten each of the the screws to assure that it is tight
against the vehicle's headliner.
Step-11 Tighten the Vehicle's Driver and Passenger Side #8 Torx outer pivot bracket mounting screws as shown in Figures 25 and 26.
Step-12 Route the SuperVisor's Cable as desired.