Code 3 Sprinter 24 Volt User Manual
Page 13

13
PROGRAMMING CAPABILITIES:
(Pass Code must be entered to make certain program adjustments,
Contact your dealer to obtain Pass Code if needed)
Item: Label: Operation:
Activation:
Description:
FEATURES THAT ARE PROGRAMMABLE:
1. Setting light switch functions
2. Selecting different siren Wail/Yelp tones
3. Selecting different 2nd siren tones
4. Selecting different Manual siren tones
5. Programming the EMERGENCY key functions
(Normally, the programming mode is Pass Code protected,
Contact your dealer to obtain Pass Code if needed)
ALT, PROGRAM
Enters the program mode
ALT & PROGRAM
of the control head.
keys will lighted
(If the Passcode is
not
entered
within
5
seconds,
the
unit
will
return
to
the
idle
condition)
Once
the
4
digit
code
is
entered,
the
controller
will
beep
and
the
ALT
&
PROGRAM
keys
will
be
lighted.
(Pressing CLEAR while in the programming mode
will exit programming without saving any
changes made during the programming session.)
PROGRAMMING STEP #1:
LIGHT SWITCH FUNCTIONS:
Beginning programming mode, the following keys will be illuminated:
, , ,PRIMARY, SEC, LIGHT
Indicating Step #1 in
Each key will light
programming
mode.
according
to
its
current
program
state
of
operation.
STATES OF OPERATION:
#1 Alternate:
LED
on #3
Timed: LED fast flashing (0.25 sec.) If not lit, it could be
#2 Flashing: LED flashing (0.5 sec.)
#4 Momentary:
LED off
set to momentary
(pressing a key will cycle it through the different states of operation)
mode.