Code 3 Shield Mini Bar - Manual (Page 4)

4
Wiring Instructions
Magnetic Mounting:
The magnetic mount beacon is equipped with a lighter plug with two rocker switches, that plugs into a 12 Volt
DC cigarette lighter outlet; rotate and push with reasonable moderate force to insure the best possible connec-
tion.
Permanent Mount:
For Permanent Mount applications, Red wire should be wired to +power through a 5A or 7.5A fuse. The Black
wire should be connected to a good chassis ground. For best results choose a ground point that is bonded
directly to the vehicle battery's negative terminal.
Operation:
Setting the Flash Pattern:
The Shield™ LED Mini-Bar flash pattern can be changed in one of two ways depending on the configuration
of your Mini-Bar. For units equipped with a Lighter Plug, a momentary action rocker switch is located on the
Lighter Plug. The flash pattern will be advanced on step each time the switch is pressed. For units intended
for Permanent Mounting, the blue wire in the cable will allow the flash pattern to be advanced (similar to the
above description) each time the blue wire is tapped to +Power. After the desired flash pattern is selected the
bare end of the blue wire should be covered with heat shrinkable tubing and taped back on the outer jacket in
case you want to change the flash pattern again in the future.
PATTERN NO. PATTERNS
1 Cycle Flash (Factory Default)
2 Single Flash (split)*
3 Double Flash (split)*
4 Quad Flash (split)*
5 Five Flash (split)*
6 Picket Fence*
7 Ten Flash (split)*
8 Single Quad Flash*
9 Single H/L (split)*
10 Double (all)
11 Quad (all)
12 Five Flash (all)
13 Fast Flash (all)
14 Ten Flash (all)
15 Single Quad (all)*
16 Single H/L (all)*
17 2 head Rotating
Flash Patterns: