Code 3 MC SuperVisor PI Utility - Manual (Page 4)

4
FIgURE 16
FIgURE 7 FIgURE 8-DRIVER SIDE SHOWN FIgURE 9
FIgURE 13 FIgURE 14 FIgURE 15
FIgURE 10 FIgURE 11 FIgURE 12
Installation and Mounting Instructions: Cont.
Caution: Drilling into the housing of the light bar could damage wiring or other internal components.
Wiring Instructions
Finish routing the cable as desired. It is advisable to leave an extra loop of cable when installing the light bar to allow for
future changes or reinstallations. For wiring of the Multi Color SuperVisor, see pages 5 & 6.
LED Fusing Considerations
NOTE: The Components of the Multi Color SuperVisor System are circuit protected by the Multi Color SuperVisor System CC
Board so the individual wires in the System do not require fusing.
DO NOT APPLY 12 VOLTS DIRECTLY TO THE SUPERVISOR WIRES AFTER IT IS CONNECTED TO THE
SUPERVISOR MULTI COLOR CC BOX. THE MULTI COLOR SUPERVISOR CC BOARD OR THE LIgHT
HEADS COULD BE DAMAgED BY APPLYINg 12 VOLTS TO THE CC OUTPUTS! WARNINg!