Code 3 Inner Compartmental Light - Manual

1
INSTALLATION &
OPERATION
MANUAL
DOME LIGHT,
HALOGEN &
INCANDESCENT
Read all instructions and warnings before installing and using. Read all instructions and warnings before installing and using. Read all instructions and warnings before installing and using. Read all instructions and warnings before installing and using. Read all instructions and warnings before installing and using.
This manual must be delivered to the end user of this equipment. This manual must be delivered to the end user of this equipment. This manual must be delivered to the end user of this equipment. This manual must be delivered to the end user of this equipment. This manual must be delivered to the end user of this equipment.
IMPORTANT: IMPORTANT: IMPORTANT: IMPORTANT: IMPORTANT:
INSTALLER: INSTALLER: INSTALLER: INSTALLER: INSTALLER:
1. Using the mounting diagram below, cut the mounting holes for your light.
2. Feed the lamp assembly wires through the hole shown below. The WHITE or RED wires are for high power
operation and the BLACK wire is for low power operation. Use appropriate wire connectors.
3. Insert the lamp unit into the mounting hole. Be sure no wires are caught between mounting surface and lamp unit.
4. Attach the lamp to the roof of the vehicle using appropriate size screws.
WARNING! You can not have insulation of any kind covering the back of the lighthead. This will cause
excessive heat to build up.