Code 3 FM 9000 - Manual (Page 6)

6
Maintenance
Make sure power is disconnected to the lightbar before servicing. Refer to Figure 4a. To remove
the lens, remove the 4 screws on each endcap as shown. Remove all clips (Figure 4b) on the front
face of the lens and frame with a flat blade screwdriver.
Please note that the lens comes off the front! It does not slide out. Pull down on the top of the
lens as shown in Figure 5a. Once the top part of the lens is out, rotate the lens down and out as
shown in Figure 5b.
If an LED assembly is not working, refer to the troubleshooting section. If it needs to be removed,
disconnect power to the module by pulling apart the red quick connect terminal and unscrewing the
black ground lead. Remove the sheet metal screws holding the assembly. Halogen assemblies
are removed in the same manner.
Before reassembling the lens, make sure the gasket is properly seated.
Figure 4a
PLACE BLADE
SCREWDRIVER
HERE AND LIFT
CLIP OFF
T01777 - LENS CLIP
PULL TOP OF LENS DOWN AND
OUT OF FRAME TRACK
ROTATE LENS DOWN AND AWAY
FROM FRAME TO REMOVE
Figure 4b
Figure 5a
Figure 5b