Code 3 C3100 Series Speaker - Manual (Page 5)

Remove the 2 nuts from their bolts and mount the bracket ( with speaker
attached) securing it with the 2 nuts you removed (Figs. 2 & 3).
Extend the BLUE (Positive) and WHITE (Negative) speaker wires to your
siren amplifier and connect as shown in the amplifiers instructions.
Test the siren for proper operation.
Installation / 2001 Ford Taurus:
The speaker will mount in the area usually occupied by the Antilock Brake
System (ABS). If your vehicle is equipped with ABS you cannot mount the
speaker in this location.
Otherwise, the C3100 speaker will mount under the battery tray. First, you
will need to remove the battery tray, and the air filter and housing (Fig. 5).
The siren bracket will mount to the driver’s side of the engine
compartment, on the side wall.
Disconnect the
ground terminal from
the negative post of
the battery, remove
the battery and tray
and then remove the
filter and housing.
Attach the bracket to
speaker as shown in
Fig. 6.
Position the bracket
and speaker onto the
mounting area. Try
not to position it too
far forward so the
siren is muffled. Be
sure the bracket
doesn’t interfere with
any existing vehicle
components. Be sure
the bracket is not too
near any existing
holes on the mounting
Fig 5
Fig 6