Code 3 920-10TH Flashers - Manual (Page 3)

3
IMPORTANT NOTES:
•••••
The use of a flashing headlight system may be regulated by state,
county, or municipal authorities. It is the responsibility of the end user
to comply with these regulations.
•••••
Before attempting the installation of the 920 headlight flasher, thoroughly
read and understand instructions and steps shown below.
•••••
Disconnect the battery from the electrical system
before attempting any part of this installation.
•••••
Have your “Tahoe Police Package Owner’s Manual Supplement”
available for reference.
Installation:
1. Locate and remove the passenger side inner fender fasteners that
secure the inner fender covering the area that the flasher connec-
tors are located. Remove or pull back this panel to gain access. Fig 1
NOTE: Each fastener must be returned to its original location when re-
installing this panel.
Fig. 1