Code 3 920-06 Flashers - Manual (Page 4)

4
3. Using the bolts removed in the
previous step, secure the head-
light flasher bracket to the pillar.
Make sure that the flasher is
oriented as shown in fig. 2.
4. The necessary electrical connec-
tions will now be made. Follow the
appropriate procedure for your
vehicle.
Wiring:
Vehicles equipped with Chevrolet Option SEO 6J3
1. Disconnect the headlamp harness’ water-proof connection adjacent to
the installed flasher.
2. Plug the water-proof flasher plugs into the appropriate water-proof
harness connection referenced in the previous step. Make sure that these
plugs fully engage the harness receptacles.
3. Locate the DARK GREEN/RED, 16-gauge control wire under the
instrument panel (refer to your ”Impala Police Package Owner’s Manual
Supplement” for specific information regarding the location of this wire).
4. Connect this DARK GREEN/RED wire to a customer supplied switch.
Vehicles without Chevrolet Option SEO 6J3
1. Disconnect the headlamp harness’ water-proof connection adjacent to
the installed flasher.
2. The flasher’s pin-housing connector includes a RED wire. Cut this wire at
the connector.
3. Plug the water-proof flasher connector into the appropriate water-proof
harness connection referenced in the previous step. Make sure that
these connectors fully engage the harness connectors.
4. Using appropriately sized wire, extend this RED wire to a customer-
supplied switch.