Code 3 2011-2013 Explorer and Ford PI Utility - Manual (Page 3)

3
WIRING CONNECTIONS:
Extend the BLUE (Positive) and the WHITE (Negative) speaker wires to your siren
amplifier and connect as shown in the amplifiers instructions and test the siren for proper
operation.
Notes:
Re-installation of vehicle facia:
1. Pre-determine wiring connections for speaker to wiring harness prior to re-installation of
vehicle facia.
2. Place vehicle facia into place and set top engine shroud over top edge of facia.
3. Place (2) plastic push-in fasteners through top engine shroud to hold it in place.
4. Hand insert and start one hex head fastener on each end of top engine shroud and through
the top leading edge of front facia. (These will hole facia in place for further installation)
5. Lift the wheel well trim cover and place facia into edges around each headlight and snap
trailing edge of facia into groove around front wheel well. The facia will snap into place on
each side of the vehicle at this point.
6. Re-install phillips head screws into sides of front facia and around each wheel well.
7. Re-install hex head screws along underside of facia behind air dam of lower facia.